Custom Wheels help ?? from Will Watson

[DJW63PW]

Does anyone know how i can get ahold of a subscriber who had a post on 1-27 -13 about a set of wheels he had made.. W A Watson II . thanks.

[Nick]

Im sure Will will be on here soon to reply, give him a little bit.

[DJW63PW]

Thanks I'll be awaiting his reply

[Nick]

maybe edit the title of your post asking for Will Watson to get his attention

[DJW63PW]

Hope that helps , thanks

[Gordon Maney]

I sent him a note.

[W_A_Watson_II]

Sorry for the delayed response, I've away from the net. What are you looking for? on my wheels?

http://m37.wawii.com/

Wheels: Custom MRW (Marsh Racing Wheels) Bead Lock Wheels
Tires: Super Swampers - IROK 39.5x13.50-17LT tires

Let me know and I'll help as best as I can. Might be a day or two though.

Will

[DJW63PW]

wheel fit

I saw an old thread about the wheels you had made with all the measurements for the wheels and where they were made. question # 1 did they fit just right or would you make any changes with the offset ? #2 what size tire did you end up putting on them and how big can you go without changing anything or rubbing? I have a 63 WM300. thanks for the help!! Dan

[W_A_Watson_II]

DJW63PW,

The only chnage I'd make is you need a 40 bolt bead lock rather than a 20 bolt like I have. Fit is great, only rubbing with my tires is the inside of the bed wheel wheels on hard articulation, and the inside of the front rear fenders on the close out panel a little.

Tires: Super Swampers - IROK 39.5x13.50-17LT tires

As for other changes I made for these tires to fit, I'm running a 1/2" block in the rear, and have a couple of extra short leaves in the front.

On a PW with the wider axles the issue shoould be less of an issue, as I and many others run 1100-16's on stock PW wheels with no clearance issues.

Will

[DJW63PW]

Thanks for the info, i'll put it to good use.