Tweet
I got the pre bent brake lines from VPW. Nn the rear axle, the drivers side line was a bit short and took a bit of "adjustment" to get it to fit and tighten down properly at both ends. With all that, it doesn't line up with the factory hold down clamps. The passenger side line is at least a 1/2 to 1 inch short and would take a lot to maybe get it to go together at both ends. Has anyone else used these and had this problem?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
- Power Wagon T-Shirts are now available for purchase on-line through the Store. They are only $15.00 each plus shipping. Shirts are available in sizes from Small thru 4X and are Sand in color. Design/Logo is printed on the back of the shirts and the front is free of any designs.