Tweet
what is the pinion bearing preload specification on the 9.625 differential. i am in the process of changing gear ratios from a 5.83 to 4.89 gears and i am installing new bearings. right now i am in the mock up stage.
-
-
this is in a 57 power wagon. it has three pinion bearings. -
If you are using all new bearings, the pinion bearing preload is best at 20 - 25 in.lbs. Should be measured with the center bearing cone held off (held out of contact with) its cup. The preload setting is between the inner and outer pinion bearings only.Comment
-
9.625
thank you for the information. this is the first one of these i have rebuilt. i am used to the ford 9inch and other half ton stuff. i am sure i will have other questions but this will do for now.Comment
Comment