spacer plate

[67 wrench]

I am looking for the spacer plate that goes between the carb and intake for a square top the one that is narrow on one side so the carb sits level.

thank you Jim

[Gordon Maney]

You would have better luck posting here:

http://www.powerwagonadvertiser.com/...splay.php?f=11

Also....

Send me an ad for Power Wagon Advertiser magazine, up to 100 words free. It must include an area code and phone number, since a lot of readers are not on the web.

Email your ad using the contact us link below.

For more information, go here:

http://www.powerwagonadvertiser.com/placead.html

[Clint Dixon]

I am looking for the spacer plate that goes between the carb and intake for a square top the one that is narrow on one side so the carb sits level.

thank you Jim

Are you asking about the adapter plate that is about 1/2" thick and its purpose is to reorient the manifold bolt pattern 90 degrees so that the studs are no longer in a line perpendicular to the axis of the crankshaft, but are now parallel to the axis of the crankshaft? This plate is not tapered on the civilian WDX-WM300 Power-Wagon. I have seen tapered ones on the WWII 1/2-ton Dodges.

Or, are you asking about the thin restrictor plate that gets sandwiched between two thick gaskets between the carb and the manifold adapter plate? This one is not tapered either.