Tweet
my 75 decided not to start today.Not gettin any fire.Im getting power to the coil but none to the distributor.checked the voltage reg. and replaced the ballast resistor.no luck.I did notice the old resistor was getting hot when I was trying to start it. any suggestions appreciated.
-
-
Did you check the coil? -
ecu ? replaced ? ensure mounting screws have good\clean contact to fire wall.Comment
-
email me for the wiring diagrams / you can do whats called a scratch test from the DIST plug with a test light to see if the ECM will fire the coil / you should also have 7 to 8 volts at the coil positive key on and a full 12 volts at the coil positive cranking / you can also do the scratch test at the coil negitive
dodgeboysnet@hotmail.comComment
Comment