headliner

[horace]

My headliner is really good except for sag over the driver. How do I fix it? The door panels aren't bad except I suppose there's grease film on them. Ideas, Thanks

[Ron in Indiana]

The factory fix was to insert a strip of wood slat above the center bar and run screws through the cardboard on each side to pull it up. This would be unsightly in my opinion but with trim screws and trim washers it wouldn't be terrible short of getting a new headliner. I do make headliners for PG's or did I should say. My board supplier doesn't carry it at present.

[horace]

thanks it's a smaller sag, what have you used to clean that material or is it better left alon? Thank you Gerry