Tweet
Anybody got a set to fit my Rockwell axle?
-
-
I have a set that supposedly will work. I got them off of Ebay a few years back, before I even owned my W600. I haven't took off my drive flanges yet to see if they'll actually fit. They are Selectro type hubs, made by "Perfect Circle". I'm hanging onto them for the time being.
I'm pretty sure Dodge didn't offer them, but Ford did on their F600 4x4. Possibly International Harvestor too, on their 2 ton 4x4.
I believe all three makes used the same Rockwell axles & T223 t-case.
Here is an old thread where I show the front axle of a mid 70's F600. It had the lock-outs, they're in the 2nd picture.
http://www.powerwagonadvertiser.com/...highlight=f600
Your best bet may be to post on one of the Ford truck forums.
Good luck! I hope your truck is coming along well.
Bucky
Comment