Tweet
I have a 68 w100 1/2 ton.
Where the driveshaft from the transmission enters the transfer case aft of the U joint there is a yoke that holds the U joint and goes into the transfer case. Mine is worn out a bit. The drive shaft was off center slightly. It does look like I have found the part.
Is there a fix or temporary fix short of replacing the yoke ?
Where the driveshaft from the transmission enters the transfer case aft of the U joint there is a yoke that holds the U joint and goes into the transfer case. Mine is worn out a bit. The drive shaft was off center slightly. It does look like I have found the part.
Is there a fix or temporary fix short of replacing the yoke ?
Comment