Announcement

Collapse
No announcement yet.

MasterYota: Centered rear t/c output options M37

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • MasterYota: Centered rear t/c output options M37

    For some reason I can't post photos on how to make the M37 adapter flange to run a driveshaft off the M37 ebrake yoke. Maybe I need to upgrade my profile.


    Options:
    Use the Dodge WC 3/4 or 1.5 ton rear t/c yoke. It replaces your M37 ebrake yoke. I just used the ebrake yoke of a Wc62. Just swapped the M37 ebrake yoke flange for the WC's. I did not get around to installing the driveshaft.

    Helitool has its tech section showing the swap. Or, make a flange adapter and run the M37 ebrake yoke and rear driveshaft as is - easiest.

    WetCj did this (Let me know if you want this removed - my email link to you no longer works):
    http://img58.photobucket.com/albums/...x/116_1683.jpg
    http://img58.photobucket.com/albums/...x/116_1682.jpg
    http://img58.photobucket.com/albums/...x/116_1690.jpg
    http://img58.photobucket.com/albums/...x/116_1691.jpg

  • #2
    Thanks Drew!

    Those pictures are exactly what I was looking for. I still have a couple of questions though:

    Are the holes in the ring threaded for the M37 flange bolts? Or was the second pattern drilled into the drum as well with everything through-bolted?

    How thick is the steel adapter ring?

    Are you happy with the Driveline angle as you see it?

    If I decide to go with the WC series yoke, can you reccommend a vendor to get one from?

    Thanks again Drew, this was really helpful!

    Ray

    Comment


    • #3
      Email me.
      Maloney_----_-_--__am@hotmail.com

      just delete the"--__--_-" anti-spam stuff from the addy and put "Dodge t/c" in the subject.

      Comment

      Working...
      X