Tweet
I was wondering if it is possible to weld mild steel to an old chrysler torsion bar. I assume the torsion bar is spring steel but don't know for sure since the bar gets twisted when on the vehical.
-
1949 B-1 PW
1950 B-2 PW
1965 WM300
1968 D200 camper special (W200 conversion)
1970 Challenger RT 383
1987 Ramcharger 4x4
1991.5 W250 diesel
1999 Jeep Cherokee limited 4x4
2008 Jeep Wrangler Sahara -
Don't waste your time.
The weld will break off the bar or break the bar from being brittle.
The heat takes the temper/spring out of the bar.
You can cut a spring on the ends,but that's it.
Take Care!
TGPWDX & Misc. Pics.
http://www.t137.com/cpg/index.php?cat=10010
"47" Dodge WDX WW
"52" Dodge M-37 WW
"54" Willys M38A1
"65" Kaiser M35A1 WW
"77" Chev. K-30 400T,205,4.56 "No-Spin"
"84" Chev, K-30 Cummins 6-BTA 400,205,3.73Locker
"86" Chev, M1028A2 (K30) 6.2,400.205,4.56 Locker
"99" Dodge Durango "Limited Slip"
"99" Dodge 3500 CTD 4x4"No-Spin" -
Second that. Waste of time.Comment
Comment