Tweet
image_12210.jpg I am replacing my wheel cylinders and had to use my long screw driver to take out the screws on the brake drums. I had a piece of metal laying in my toolbox and it was exactly the same width as the screws. I grabbed some scrap oak strips, put a groove in on of them for metal to sit and I glued them together. I haven't put a screw through the handle yet, but it works.
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
- Power Wagon T-Shirts are now available for purchase on-line through the Store. They are only $15.00 each plus shipping. Shirts are available in sizes from Small thru 4X and are Sand in color. Design/Logo is printed on the back of the shirts and the front is free of any designs.
Comment