1/2 ton front fender help needed

[Kevin in Ohio]

Does anyone know of pics showing the T shaped rubber gasket that attaches between fender and cab? My originals are long gone so I have no guide to go by. Would like to see what Dodge did on the ends and where they stopped. Any help appreciated. Truck in question is a 1941 WC 40 closed cab.

[ejowest]

On the third page down shows the t molding your looking for.

T-molding

[Kevin in Ohio]

On the third page down shows the t molding your looking for.

T-molding

I can't seem to get the pic to come up but if it's Vintage's catalog I have that. I just got the T weatherstrip from them and want to see where it extends to and how Dodge trimmed the ends. Too expensive to make a mistake. They sent a single 51 inch piece but the catalog says a pair. I'm assuming you cut 2 pieces from the one?

[ejowest]

I bought the t-molding for my WC21 restoration from VPW but I am not quite at the point to install it yet.