PW Cab Mount Demensions/Measurements

[W_A_Watson_II]

Jerry,

Sorry to here about being out of the fun for a bit, hope the eyes heal well and you are back at it soon.

Yep, the lines you picked should be good ones. If your running boards were sloped down hill in the rear I'd question the rear cab mount blocks, but they seem to rune true to the body line.

I don't have a higher resolution image of the last two drawing, but I do have a high resolution version of the Body Builders Layout (2775x2269) if you need it.

[Jerry Henry]

Thanks. My vision is already amazingly better. These cataracts came on slowly and I have put off having them removed, so it's like a blind man seeing again.
Do you have a picture of a bare frame shown at a side view that you could post for me? At this point I don't know what I can or will do about this, but it would be interesting to have a picture to look at. If it's not too much trouble. Thanks.

[W_A_Watson_II]

Jerry,

Glad to here the vision is better. I don't have a side view, just a rough angle view from the rear.

Will

[Jerry Henry]

If it is low enough to show the plane of the frame from behind engine area to the rear it might help.

[W_A_Watson_II]

Jerry send me an email W_A_Watson_II (at) hotmail.com

[W_A_Watson_II]

What is the height difference between the lower below the door valance heights between the Job-Rated (and/or WC) and Power Wagon Cabs?


I ask as I'm building my new Cab Dolly, and want to not exclude a Job Rated or WC cab from also fitting on it if needed in the future.