If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Power Wagon T-Shirts are now available for purchase on-line through the Store.
They are only $15.00 each plus shipping.
Shirts are available in sizes from Small thru 4X and are Sand in color.
Design/Logo is printed on the back of the shirts and the front is free of any designs.
As long as you are aware of the side effects of putting a locker in your truck, there is no reason you couldn't do it. Lockers are expensive, so if you wanted to install, or find an axle with one already installed, that's your call.
Turning on a slick surface can cause both tires to lose traction. Turning on solid surface is also hard, one tire may scrub across pavement if its forced to rotate same amount as the opposite tire, even though traveling a different distance.
Most issues involve turning. Straight line travel usually doesnt cause problems.
A lot depends on the type of locker you install. My first 4x4 was a 78 W200 with a factory limited slip rear and 4:10 gears. It too was a full time and I never had any bad driving habits from that set up. I went through a lot of "stuff" especially deep snow. The set up is the key with the Dana 60 you probably have unless it's a half ton. It's worth the time and money if you are off road or in the slippery stuff a lot. I loved full time 4 wheel.
I had a Detroit in the rear and an ARB in the front of my '77 W300. There were no adverse effects with the Detroit, but this was a dually with a walk-in service body. 2,000 miles later the truck was stolen. Big ;(
A "Locker" like the Detroit is a all or nothing device and will "ratchet" going around corners. They are more of an off road or drag application. You hear them sometimes depending on the radio level and you will feel them engage and disengage.
An "LSD" Limited Slip Differential" uses a (usually) clutch pack and spring system to gently limit the free wheeling. Eaton (factory) is an example of LSD. You don't know it is there until you are in a foot of snow and realise you can actually go. Either is great for doing donuts in the winter. I love my Eaton, my last Auburn LSD was awsome.
Down side....
You have to learn to drive with it, if you hit the throttle with it on a corner it will swap ends on you real fast. Careful, or playful....;-)
Yep. My '92 has a LSD but not full time and it makes a world of difference. My dad has an identical '93 W250 with an open diff and he spins out in a level yard...
But my full time M880 with open diffs can run circles around the '92. I think mainly due to the lead anchor over the front axle called a Cummins.
I remember my dad had a '68 Coronet when I was a kid. He just put in some kind of locking diff and we went for a test drive after a recent rain. Going up a hill the tranny downshifted (or he stepped on it...) and the next thing I knew we we going down hill in the opposite lane like nothing happened.
1951 B-3 Delux Cab, Braden Winch, 9.00 Power Kings
1976 M880, power steering, 7.50x16's, flat bed, lots of rust & dents
1992 W250 CTD, too many mods to list...
2005 Jeep KJ CRD
The biggest issue is having a non-differentiating differential while going around corners on pavement. if you don't mind chirping tires your golden. If you do, look for a selectable locker. My personal favorite is the OX locker, since it uses a cable for operation, making it most reliable.
after lots of research, price comparison, and brain pickin of the members of this forum. I came to the conclusion that the manual OX locker was the best solution. then I found out OX doesn't make a locker for the Dana 70. a little searching of these forums may reveal the entire thread discussing lockers. pros and cons of each .
Comment