pop top ramchargers

[Jeff in N.Tx.]

Maybe Ron will come and see us in Texas again. Then he can pick them up on his way beck to Indiana. He will need a break from the snow and ice this winter.
Jeff

[74w300uteline]

I think

Ron may be getting tired of dragging my cr-p around. You never know, warm weather is a great motivator. what carb do you recommend

[74w300uteline]

got a rollbar

it's from an 87 ramcharger. floor styles changed in 81. so i need to shorten the legs a bit . anybody here done the shortening thing.

[KevinM]

....Hacksaw............

[QuantumJo]

mechanic says "both lifts were done correctly

Is the lift all suspension? What size tires are on it?

[74w300uteline]

lift & tires

tires are 35x12.5
not an expert on lifts, but there is a 2.5 inch block on top of the factory block, on the rear axel.
I wanted to add running boards that i had laying around but, the front tire rubs at full turn. no worrys this thing is gonna be a blast at Lee Mass Power Wagon rally. fill it up with cheerleaders and off we go.

[oldmopar]

Not sure how far from you but here is a 79 being parted out in PA

http://poconos.craigslist.org/pts/2213229584.html

[OLD DODGE]

Convertible Tops

Introduction

[OLD DODGE]

Part numbers. Note the early version as was discussed previously in this thread.

[OLD DODGE]

Babe Magnet

Women find them irresistible!

[74w300uteline]

cool brochure. rollbar feet?

super cool marketing brochure, but not enough cheerleaders. 250 dollars!!! Where is the timecapsule warehouse full of these tops. a used bestop repro went for 800$ recently on ebay. Somebody could make a good buck reproducing soft tops and the rubber gaskets for the removable hardtop.

my roll bar arrived and there are 4 metal plates that came with it. where do these go? two are flat two are curved. floor of truck or under the floorpan? I dont see predrilled holes in the floorpan so I'm guessing I need to drill my own holes.

[OLD DODGE]

Andrew,

I assume your rollbar has plates welded to the ends so those are probably the ones that go under the floorpan and sandwich the sheet metal in between. I will look and see if I have anything on it. Is it a Chrysler part? Got a picture? With cheerleaders?